FEASIBILITY ANALYSIS OF AIR FLOATING DESIGN FOR ELECTRICITY GENERATION

A. Kalikova, S. Kusdavletov

Аннотация


In the past several decades, there were presented different innovative technologies rather than traditional wind turbines for renewable energy that uses wind kinetic energy and remains in the air through aerodynamic forces. Unlike wind turbines with towers, their systems operate in a flight, and they are connected to a foundation by a cable that either transmits the energy generated at the airfoil or transmits mechanical energy to the ground. Nowadays, there are several existing and developing technologies; however, each of them has limitations and challenges. This work will present an analysis of air floating design for electricity generation at high altitudes. It is a tethered wind turbine with a Balloon system, which has a simple controlling system, relatively higher efficiency, and low-cost technology. The concept of the design is to model the electricity generation device powered by clean renewable energy, mainly wind power. Base on the concept of kite or helium balloon to provide enough buoyancy to keep the device working at certain altitude. To increase the energy conversion efficiency and the feasibility of the device, it is mostly used in the country, open area. Despite high efficiency which needs further investigation, the designed device is moveable, pollution free and little space consumed.

Ключевые слова


renewable energy, wind turbine, helium balloon, controlling system

Полный текст:

PDF (English)

Литература


Darwish, A. S., & Al-Dabbagh, R. (2020). Wind energy state of the art: present and future

technology advancements. Renewable Energy and Environmental Sustainability, 5, 7.

Mendis, P., Ngo, T., Haritos, N., Hira, A., Samali, B., & Cheung, J. (2007). Wind loading on

tall buildings. Electronic Journal of Structural Engineering.

Hau, E. (2013). Wind turbines: fundamentals, technologies, application, economics. Springer

Science & Business Media.

Vermillion, C.; Glass, B.; Rein, A. (2013) Lighter-than-air wind energy systems. In Airborne

Wind Energy; Springer, (pp. 325-380).

Hansen, J. T., Mahak, M., & Tzanakis, I. (2021). Numerical modelling and optimization of

vertical axis wind turbine pairs: A scale up approach. Renewable Energy, 171, 1371-1381.

Zhang, H. (2013). Kite modeling for higher altitude wind energy.

Bolonkin, A. (2014). Innovations and New Technologies (v. 2). Lulu. com.

Arturo Soriano, L., Yu, W., & Rubio, J. D. J. (2013). Modeling and control of wind

turbine. Mathematical Problems in Engineering, 2013.

Van Der Vlugt, R., Peschel, J., & Schmehl, R. (2013). Design and experimental

characterization of a pumping kite power system. In Airborne wind energy (pp. 403-425).

Springer, Berlin, Heidelberg.

Segalini, A. (2021). An analytical model of wind-farm blockage. Journal of Renewable and

Sustainable Energy, 13(3), 033307.


Ссылки

  • Ссылки не определены.


(P): 2707-9031
(E): 2707-904X


Нур-Султан
Бизнес-центр EXPO, блок C.1.
Казахстан, 010000

sjaitu@astanait.edu.kz